Looking for a gauge console that fits in the center dashboard tray (whatever it called). I wanted the one that is pictured below but manufacturer said it will not fit the gen 2s.
Found this one. Know zero about it. http://ortizcustompods.com/store/p1816/2018_Ford_F-150_Raptor_-_Triple_Dash_Panel_-_OCPF-New.html
That looks good. I would be interested in finding out as well. I will also look and let you know if I find anything.
I ordered and just received the item I had pictured in the original post. I believe it will work out with a bit of mini-cell foam as a base and Velcro. Will post pics when done unless it's a mess.
It fits almost perfectly front to back and just a little gap on the side. Nothing too bad. I’m ordering some mini cell foam for the base as the gen2 is deeper than the gen1 tray. It’s going to look pretty good.
that one provides the same gauges you already have in your digital screen, personally I dont see the point.
Do they sell the pods without the gauges? Two reasons for asking... As JaRod mentioned, these are redundant to some degree. Plus the ones that it comes with are really cheap, a high end gauge (AutoMeter) can cost as much as the whole unit.