RMB Motorworks - https://www.rmbmotorworks.com/ located in Wayne, NJ. RMB is one of the best Raptor/F150 shops in the country. Its a little...
i strongly recommend Raybestos slotted rotors and Ceramic pads. The stoptech product is junk in my experience
everyone is doing the same thing and they all make about the same power. Intercooler and tune are all you really need. Install should take no...
let me know your location, I can find a competent shop to refer you to. geoff[at]full-race.com is my email address
If the tune is safe, with no knock and conservative ignition/fueling values there is nothing wrong with 22-23psi boost. Especially on a 2018, fyi...
Max, this depends on your intercooler and piping setup. I suggest speaking with [email protected]
the oem Ebov can start leaking around 21-23psi. it also has a rubber diaphragm that can eventually tear over time. Therefore, we recommend...
bravo3eco why are you constantly posting misinformation?? if someone plans to keep their truck for a long time, it would make sense to have a...
The diagnostic system does not like it when you remove sensors. Instead you would want to keep everything plugged in and operational. Tuners...
Keep in mind all 17+ Raptor and F150 will require a tune for any catch can installation this is a false myth. the 17+ has dual injection, for...
none that i am aware of. You can leave things in place, the only change is to how your tuner chooses to set sensitivity of a fault code being...
not recommending anything here... but... a tuner can disable that sensor and code through a tune
the crank is very good, and very strong. OEM raptor rod and piston are stronger than oem F150 rod and piston but the piston is the weakpoint...
thanks guys, i am working on a few updated Raptor writeups to our site this week. hopefully this will help clear up questions
we are located in Phoenix, AZ at the northeast side of Sky Harbor airport! feel free to stop by, or to email us anytime. We build performance...
fully agree on most of this, but a few edits: -spark plugs should be gapped to 0.025" at the largest, 0.028" is ok but 0.030" is too large in our...
port injection is used for cold start and supplementary fueling in boost. DI has a tremendous amount of soot (particulate) emissions during cold...
install is not easy or inexpensive, considering the purpose and stated gains. I can not figure out how most people do this without pulling their...
the answer is "it depends". Meaning it depends on the dealership's knowledge and mindset as well as which brand intercooler you use. I know we...
I suggest speaking to swarfworks ! the majority of intercoolers will not work with a winch
@DrDJin with all due respect that is not accurate
the new 3.5L in the Raptor is the first engine in the Gen2 EcoBoost family. Its very different from the older 11-16 3.5L ecoboost, most...
Separate names with a comma.